Description
Mounting strip for 12 mm pixels, black, 50 m roll, hole pitch 2.54 cm (1″)
The HDPE plastic strip holds 12 mm pixels at an even spacing: the pixels are pushed into the holes, which sit at a pitch of 2.54 cm (1″). The strip is flexible and is supplied rolled. The roll is 50 m long and is cut to the required length.
Is it right for my project?
What this strip is made for
- Mounting 12 mm pixels at an even spacing — e.g. for mega trees, arches, outlines and matrices
- Straight and curved runs, the strip is flexible
- Longer runs: join several strips with cable ties via the end holes
Not suitable for
- Pixels of a different size — the holes are made for 12 mm pixels
- Load-bearing mounting without a support structure — the strip holds pixels, not loads
2.54 cmhole pitch
HDPEmaterial
0.97 mmmaterial thickness
Mounting
How to mount the pixels
-
Cut to length. Bring the strip or roll to the required length.
-
Push in the pixels. Push the 12 mm pixels into the holes from the front. The cable between two pixels must reach the chosen hole — so the pixel pitch of the string limits the hole spacing.
-
Join and fix. Join several strips via the end holes with cable ties; secure the ends with the reinforcement clips 10171.
Tip: Fix the pixel cables with cable ties at the small holes so that no pulling force acts on the pixels.
Scope of delivery
- 1 roll of mounting strip, 50 m (without pixels)
Frequently asked questions
Which pixel pitch is possible?
Any multiple of the 2.54 cm (1″) hole pitch.
How do I extend the strip?
Overlap two strips at the ends and join them via the end holes with cable ties; the clips 10171 make the ends more stable.
Technical data
Product safety information
Manufacturer information:
PIXLtec GmbH
Maybachstraße 8
Baden-Württemberg
76227 Karlsruhe
Deutschland
info@pixltec.de
